Aiming for 500 Rear Wheel KW? Introducing the GEN II GTX3582R Ford Falcon Bolt on Turbocharger! This custom-built Garrett GTX3582R GEN II is designed as a bolt on upgrade Turbochargers for the Ford Falcon BA/BF XR6 Turbo. With 800 flywheel horsepower capabilities, the GTX3582R GEN II is for the serious users who want to make over 600rwhp, in a low mounted factory bolt on combination.
The GTX3582R GEN II comes with a specifically designed 1.15a/r Turbine Housing, with a HUGE 40mm wastegate port, and 42mm Wastegate flapper.
- Bearing Type: Ball Bearing
- Cooling System: Oil and Water Cooled
- Horsepower: 600-800hp
- Application: Ford Falcon XR6 BA/BF Models
- Actuator: GCG Billet 14psi (supplied with additional 5psi spring to bring the minimum boost to 19psi if required)
- Expected Power: Proven 500rwkw+ with supporting modifications, and E85 fuel
Product Features:
- Turbine Housing - 1.15a/r Turbine Housing allows for the ultimate in performance, without sacrificing excessive boost response
- Factory Turbo Orientation - Oil Feed, Oil Drain, Water Lines and Dump Pipe connection is in an identical position to the factory setup, allowing for easy re-fitment
- Factory Turbo Position - These turbochargers still look very similar to a factory unit, and utilize the factory manifold, and exhaust system
- Ultimate Boost Control - Largest Wastegate Porting, and largest Wastegate flapper to match, ensuring consistent boost control throughout the rev range
- Supporting Re-Fitment Parts - Exhaust studs, locking nuts for the dump pipe, and a complete turbocharger gasket kit is included.
Whats left to do once it's fitted?
- Air Inlet Hose/Pipe - The factory turbocharger has a 3.0-inch Inlet, the GTX3582R GEN II has a 4.0-inch Inlet. A simple reducer hose, or a little fabrication may be required to adapt to your existing setup. Alternatively, you could purchase a Process West or Plazmaman 4" intake system, specific for the BA/BF Falcon 4" Inlet Upgrades
- Air Outlet Hose/Pipe - The factory turbocharger has a 2.0-inch Outlet, the GTX3582R GEN II has a 2.5-inch Outlet. Again, this can be as simple as a reducer hose, or some slight fabrication to make it all go together.
Thatâ??s It! - Extremely simple to re-fit, with minimal modifications to adapt to your existing setup!